Skip to content

ES7 Learn

PCB design you learn by changing things.

Short lessons and hands-on labs. Guess first, move a slider, then see why the board passes or fails. The full lessons live in ES7 Lab, built around the three boards below. It is free with an ES7 account.

Try a lab

Annular ring

The annular ring is the copper left around a drilled hole. Shrink the pad or grow the drill and watch it fall below what a low-cost fab will accept. Before you move anything: how small can the ring get on a 0.6 mm pad?

Lab · Annular ring

ring = (pad − drill) ÷ 2

bitØ0.30pad 0.60 mm · drill 0.30 mm
0.60 mm
0.30 mm

Annular ring

Tight

0.150 mm 5.9 mil

Passes, but drill wander could still nick the pad. Add margin if you can.

Learning paths

Three boards, from first PCB to four layers.

Each path is one real project in ES7 Lab. You design it, order it and bring it up, learning each idea at the moment the board needs it. Start with the Smart Plant Monitor.

Open ES7 Lab
  1. 1Live

    Foundations

    Smart Plant Monitor

    A Wi-Fi soil-moisture monitor. Your first board, taken from schematic to working hardware.

    • Schematic and footprints
    • PCB layout and annular ring
    • Ordering the board
    • Bring-up and firmware
  2. 2Beta

    Intermediate

    Indoor Environment Monitor

    CO₂, temperature, humidity and air quality on one board, with a display and shared sensor buses.

    • Switching power
    • I²C, SPI and UART
    • Noise-aware layout
    • Validation and Rev B
  3. 3Beta

    Advanced

    NAM A2 Guitar Pedal

    A programmable amp modeler: prove it on an audio platform, build a carrier, then go to four layers.

    • Audio architecture
    • Four-layer layout
    • Mixed-signal grounding
    • Audio bring-up and DSP

Interactive labs

Concepts you can move.

Each lab takes one rule that is easy to read about and hard to picture, and lets you push it until it breaks.

The ES7 Lab Smart Plant Monitor project on a desktop monitor
  • Annular ring

    Change pad and drill size and see when the ring breaks a fab limit.

    Live
  • Trace width and spacing

    See how width and gap trade off against current and manufacturability.

    Planned
  • Solder mask clearance

    Grow and shrink mask openings and find where slivers appear.

    Planned
  • Stencil area ratio

    Size an aperture against foil thickness and predict paste release.

    Planned