All toolsFree calculator
Copper-weight converter
Convert PCB copper between oz/ft², µm and mil, and see roughly how thick an outer layer ends up after plating.
Copper weight
1 oz/ft² ≈ 1.37 mil ≈ 34.8 µm
Copper
Standard1 oz/ft²
34.8 µm · 1.37 mil
A standard weight that most fabs stock. Outer layers gain the plating; inner layers stay close to the foil weight.
- Outer layer, finished
- ≈ 60 µm · 1.72 oz
- Inner layer, finished
- ≈ 35 µm (no plating)
The rule
PCB copper is sold by weight: one ounce of copper spread over one square foot. That works out to about 1.37 mil, or 34.8 µm, which fabs usually round to 35 µm.
Outer layers are plated when the holes are, so they finish thicker than the foil you order. A ½ oz start plus plating ends up close to 1 oz. Inner layers aren't plated and stay close to their foil weight.
Formula
1 oz/ft² ≈ 1.37 mil ≈ 34.8 µm µm = oz × 34.8 mil = oz × 1.37 outer finished ≈ base + plating
Typical values and sources
- The 1.37 mil per ounce conversion is the usual industry figure; IPC-4562 covers copper foil weights for PCBs.
- About 25 µm of surface plating is typical when holes are plated to the IPC-6012 Class 2 or 3 minimum. Typical value.
- Above 2 oz, most fabs quote heavy copper, with wider minimum trace and gap.
Limits differ between fabs. Treat these as starting points and check your fab's capability page.
More calculators
- Stencil area-ratio calculatorAperture size and foil thickness to area ratio, with the 0.66 release guideline.
- Via aspect-ratio calculatorBoard thickness and drill size to aspect ratio, against common fab limits.
- Finished-hole calculatorDrill size, plating and tolerance to finished hole size.
- Panel-utilization calculatorBoard size, spacing and rails to boards per panel and material use.