All toolsFree calculator
Panel-utilization calculator
Enter a panel and board size, spacing and rails to see how many boards fit and how much of the panel becomes scrap.
Panel utilization
n = ⌊(usable + gap) ÷ (board + gap)⌋
Boards per panel
81 % used30 boards
5 × 6, as drawn
At least 70 % of the panel ends up as boards. A good fit.
- Material used
- 81 %
- Board area
- 40,500 mm²
- Scrap area
- 9,500 mm²
- Other orientation
- 28 boards (75.6 %)
The rule
Boards are built on a larger panel. Tooling rails along the edges hold fiducials and tooling holes, and a gap between boards leaves room for the router. Whatever is left over is scrap you still pay for.
The calculator tries the board both ways round and keeps the orientation that fits more. If the board has to keep a fixed orientation for assembly, check the other count too.
Formula
usable = panel − rails n = ⌊(usable + gap) ÷ (board + gap)⌋ boards = n across × n down used = boards × board area ÷ panel area
Typical values and sources
- 18 × 24 in and 12 × 18 in are common fab production panel sizes; usable area depends on the fab.
- A 2 mm routing gap and 5 mm rails are typical starting points for assembly arrays. Typical values.
- The 70 % and 50 % bands are a rule of thumb for material use, not a standard.
Limits differ between fabs. Treat these as starting points and check your fab's capability page.
More calculators
- Stencil area-ratio calculatorAperture size and foil thickness to area ratio, with the 0.66 release guideline.
- Via aspect-ratio calculatorBoard thickness and drill size to aspect ratio, against common fab limits.
- Finished-hole calculatorDrill size, plating and tolerance to finished hole size.
- Copper-weight converteroz/ft², µm and mil, with typical finished thickness.